1.	Fill and sand any gaps on figure, prime and if necessary gloss varnish before decaling.
2.	Cut decal to rough fit area to covered. i.e sleeve, right side of jacket etc.
3.	Apply decal solution to area that is to be decaled. (Mr.Setter, Microset etc)
4.	Soak decal in water for a few seconds, remove from water and wait until decal becomes loose from backing sheet.
5.	Place decal in position on area of figure to be coverd, push into folds on uniform using soft brush, fingers or burnishing tool.
6.	Trim edges to follow seams with a new blade.
7.	Use a decal sofener (Mr.Setter, Microset etc) to help decal conform to figure, decal may wrinkle with some solutions before it lays down flat.
8.	If air bubble occurs prick with pin or blade and apply more solution to setting decal down.
9.	When dry apply matt varnish.
10.	Apply weathering, shading etc as to personal preference.